Proface LT4300M - 5.7 Modular HMI + Control" Instrukcja Użytkownika Pobierz pdf (Strona 46)

Communication Interfaces

English

Although LT does not restrict you from doing so, we recommend that you not exceed

16 CANopen slave modules (and/or 32 TPDOs and 32 RPDOs) for sufficient performance

tolerance and to avoid performance degradation.

CANopen Interface Pin Assignment

The graphic describes the pins of the CANopen interface:

The table describes the pins of the CANopen interface:

The shield is connected to pin 6, the 0 Vdc pin.

NOTE: Pin 9 is not connected internally. The controller does not provide power on

CAN_V+.

WARNING

UNINTENDED EQUIPMENT OPERATION

Do not connect more than 16 CANopen slave devices to the LT.

Failure to follow these instructions can result in death, serious injury, or

equipment damage.

NOTICE

DEGRADATION OF PERFORMANCE

Do not exceed 32 TPDOs and 32 RPDOs for the LT.

Failure to follow these instructions can result in equipment damage.

Pin Signal Description

1 N.C. Reserved

2 CAN_L CAN_L bus line (Low)

3 CAN_GND CAN 0 Vdc

4 N.C. Reserved

5CAN_SHLDN.C.

6GND 0Vdc

7 CAN_H CAN_H bus line (High)

8 N.C. Reserved

9 N.C. Reserved

1 2 ... 41 42 43 44 45 46 47

Brak uwag

Proface LT4300M - 5.7 Modular HMI + Control" Instrukcja Użytkownika Strona 46